36 xGen Installation & Programming Guide
Congratulations, your xGen system is now connected to your network and
UltraConnect. It is now ready to be programmed. Refer to Programming Guide
starting on page 55.
Method 3 – UltraConnect App
UltraConnect is a smartphone app that allows you to:
• Check the status of your system
• Arm and Disarm partitions
• Bypass zones
• Manage users
• Perform system programming
Access from the app is disabled by default for security. To allow access these
settings must be enabled on your xGen panel:
• Web Access Code
It permits remote access from the UltraConnect app. Set it to 00000000 to
prevent the app from connecting.
• User Name and PIN code
The UltraConnect app requires any user name and PIN code to log in to the
system and display features available to that user.
• Enable UltraConnect
Using web interface enable UltraConnect by selecting the option Settings –
Network – Enable UltraConnect
Set Web Access Code and User Name/PIN code
1. To enable the UltraConnect app click Settings
To Next Page
Loading...
Need help?
General
