10 xGen Installation & Programming Guide
NXG-001 xGen Plastic Enclosure
The xGen enclosure features a DIN rail for mounting xGen modules, a tamper
switch, and integrated cable management.
The enclosure should be installed in accordance with EN50131-1 Environmental
Class II to provide operating conditions within:
• Temperature range: -10 to +55°C.
• Humidity range: Average 93% relative humidity, non-condensing
The lid can be removed by releasing the two screws using the supplied allen key.
Refer to drilling template provided with enclosure for mounting instructions.
To install a module, release the locking tab(s) and place on the DIN rail then
push the locking tab(s) to secure the module. To remove a module, use a small
flat-blade screwdriver to release the locking tab(s) on the xGen module then
remove from the DIN rail. Refer to module installation manual for further details.
To Next Page
Loading...
Need help?
General
