To Next Page

To Previous Page

Basic Operation

1. Insert the USB flash drive into the USB interface on the front panel of the

instrument.

2. Power on the instrument. At this point, press Shift for several times till

the instrument can detect the system upgrading files in the USB flash

drive.

After the system upgrading files are detected, the interface displays as

follows:

Update Select(01/01)

SN: ALL

If the USB flash drive is not detected, select Yes to detect again; if No

is selected, it means to exit upgrading, and the system will directly en-

ter into the main interface.

3. Select ALL, and press [Enter].

The system interface displays as follows:

Update ? (01/01)

No Yes

4. Select Yes, and press [Enter].

The system will automatically perform upgrading.

If No is selected, it means to exit upgrading, and the system will di-

rectly enter into the main interface.

5. After the upgrading is completed, you need to restart the instrument

manually.

• System Upgrade under Parallel Mode (Only Need to Operate the Master)