To Next Page

To Previous Page

Basic Operation

After the data recording function is started, the lower right corner of the main in-

terface displays Logging, indicating that the data is recorded. The recorded da-

ta is saved in USB memory device in .csv format. The user can get access to

these files for analysis based on needs.

5.5 Set the Beeper Status (Beep)

The user can turn the instrument beeper sound on or off base on personal

requirement.

The beeper sound works in the following scenarios:

• A beeper sound produced when the front panel key is pressed.

• When an error is generated inside the instrument, such as when the instru-

ment receives an unprocessable command in the remote state. At this time,

the instrument produces a beeper sound, and the flag “Error” appears on the

VFD.

• When the instrument is under protection status, such as over-temperature

protection. At this time, the instrument produces the beeper sound.

The setting procedures are as follows:

1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-

ter the system menu.

The first displayed menu item Beep is used to set the beeper status.

2. Press [Enter] key to enter the parameter setting interface.

3. Press the Left / Right key or turn the knob to adjust the value of this

parameter.

• On: Default value, indicates the beeper is on.

• Off: Indicates the beeper is off.

4. After the parameter settings are complete, press [Enter].

At this point, the beeper status takes effect immediately.

5.6 Set the Power-on State (PowerOn)

This menu item is used to control the settings and input state when the load is

powered on.

The detailed power-on parameters and input state are as follows.

ITech IT8000 Series User Manual

Other manuals for ITech IT8000 Series