To Next Page

To Previous Page

IT8000 Series User Manual

• SHOCK HAZARD Ground the Instrument. This product is provided with

a protective earth terminal. To minimize shock hazard, the instrument

must be connected to the AC mains through a grounded power cable,

with the ground wire firmly connected to an electrical ground (safety

ground) at the power outlet or distribution box. Any interruption of the

protective (grounding) conductor or disconnection of the protective earth

terminal will cause a potential shock hazard that could result in injury or

death.

• Before applying power, verify that all safety precautions are taken. All

connections must be made with the instrument turned off, and must be

performed by qualified personnel who are aware of the hazards involved.

Improper actions can cause fatal injury as well as equipment damage.

• SHOCK HAZARD, LETHAL VOLTAGES This product can input the dan-

gerous voltage that can cause personal injury, and the operator must al-

ways be protected from electric shock. Ensure that the input electrodes

are either insulated or covered using the safety covers provided, so that

no accidental contact with lethal voltages can occur.

• Never touch cables or connections immediately after turning off the in-

strument. Verify that there is no dangerous voltage on the electrodes or

sense terminals before touching them.

• Failure to use the instrument as directed by the manufacturer may ren-

der its protective features void.

• Always clean the casing with a dry cloth. Do not clean the internals.

• Make sure the vent hole is always unblocked.

Environmental Conditions

The instrument is designed for indoor use and an area with low condensation.

The table below shows the general environmental requirements for the

instrument.

Environmental Conditions Requirements

Operating temperature 0°C～40°C

Operating humidity 20%～80%( non-condensation)

Storage temperature -10°C～70 °C

ITech IT8000 Series User Manual

Other manuals for ITech IT8000 Series