To Next Page

To Previous Page

Appendix

The type of the fuse The way to replace

1. Use a screwdriver to push and turn the

fuse box anti-clockwise. When turned to 90

degrees, release the screwdriver. Refer to

the picture below.

2. The fuse box will bounce up, then you can

see the fuse in it. Take out the blown fuse.

3. Please replace with a fuse of the same

specification. Refer to the technical specifi-

cation of the corresponding instrument.

4. When install, put into the fuse box as the

picture below. Then use a screwdriver to

push and turn the fuse box to 90 degrees

clockwise. Refer to the picture below.

The power cord jack of the instrument includes

the fuse. Please refer to the rear panel intro-

duction of the corresponding instrument for

the detailed position. The replacement steps

for this type of the fuse are as follows.

1. First pull out the power cord, and then take

out the fuse block from the power cord jack

with a small screwdriver, as shown below.

2. Have a visual inspection of the fuse to see

whether it is burnt out; if yes, replace it with

another fuse of the same specification. Re-

fer to the corresponding technical specifi-

cations for fuse rating.

123

ITech IT8000 Series User Manual

Other manuals for ITech IT8000 Series