EasyManuals Logo
Home>ITech>Test Equipment>IT8000 Series

ITech IT8000 Series User Manual

ITech IT8000 Series
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
Inspection and Installation
3. Press the Left/Right key to select LAN and press [Enter].
4. Press the Left/Right key to select Info and press [Enter].
5. Press the Up/Down key or rotate the knob to view the LAN parameters. See
the information in 1.8 System Menu Function for details.
Configure LAN Interface Information
The configurable parameters of the IT8000 series load are described as follows.
IP-Conf
IP: This value is the Internet Protocol (IP) address of the instrument. An IP
address is required for all IP and TCP/IP communications with the instru-
ment. An IP Address consists of 4 decimal numbers separated by periods.
Each decimal number ranges from 0 through 255 with no leading zeros (for
example, 169.254.2.20).
Mask: This value is used to enable the instrument to determine if a client IP
address is on the same local subnet. The same numbering notation applies
as for the IP Address. When a client IP address is on a different subnet, all
packets must be sent to the Default Gateway.
Gateway: This value is the IP Address of the default gateway that allows the
instrument to communicate with systems that are not on the local subnet, as
determined by the subnet mask setting. The same numbering notation ap-
plies as for the IP Address. A value of 0.0.0.0 indicates that no default gate-
way is defined.
DNS1: This field enters the primary address of the server. Contact your LAN
administrator for server details. The same numbering notation applies as for
the IP Address. A value of 0.0.0.0 indicates that no default server is defined.
DNS is an internet service that translates domain names into IP addresses.
It is also needed for the instrument to find and display its hostname assigned
by the network. Normally, DHCP discovers the DNS address information;
you only need to change this if DHCP is unused or not functional.
DNS2: This field enters the secondary address of the server. Contact your
LAN administrator for server details. The same numbering notation applies
as for the IP Address. A value of 0.0.0.0 indicates that no default server is
defined.
Socket Port: This value indicates the port number corresponding to the
service.
Serv-Conf
Configurable services include: MDNS, PING, Telnet-scpi, Web, VXI-11, and
Raw Socket.
Copyright © Itech Electronic Co., Ltd.
32

Table of Contents

Other manuals for ITech IT8000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ITech IT8000 Series and is the answer not in the manual?

ITech IT8000 Series Specifications

General IconGeneral
BrandITech
ModelIT8000 Series
CategoryTest Equipment
LanguageEnglish

Related product manuals