ITech IT8512A+ Programming Guide

Measure Commands
Copyright © ITECH Electronic Co., Ltd. 44
Chapter6 Measure Commands
This signal measure command is used to get the read back value. You can use
this command to control the measurement process.
MEASure[:SCALar]:VOLTage[:DC]?
This command is used to query the average voltage of the electronic load.
Command Syntax
MEASure[:SCALar]:VOLTage[:DC]?
Parameters
None
Examples
MEAS:VOLT?
Returned Parameters
<NR2>
MEASure[:SCALar]:VOLTage:MAXimum?
This command is used to query the peak voltage of the electronic load.
Command Syntax
MEASure[:SCALar]:VOLTage:MAXimum?
Parameters
None
Examples
MEAS:VOLT:MAX?
Returned Parameters
<NR2>
MEASure[:SCALar]:VOLTage:MINimum?
This command is used to query the minimum voltage of the electronic load.
Command Syntax
MEASure[:SCALar]:VOLTage:MINimum?
Parameters
None

ITech IT8512A+ Specifications

General

Brand	ITech
Model	IT8512A+
Category	Test Equipment
Language	English