ITech IT8512A+ Programming Guide

Peak Testing Commands
Copyright © ITECH Electronic Co., Ltd. 54
Chapter8 Peak Testing Commands
These commands are used to read the maximum/minimum value after startup
test. Peak value recording is automatically cleared when the Peak test is
started.
PEAK[:STATe] <bool>
This command is used to set the peak test status.
Command Syntax
PEAK[:STATe] <bool>
Examples
Peak:ON
PEAK CLEar
This command is used to clear the peak record.
Command Syntax
PEAK CLEar
Examples
Peak CLE
PEAK:VOLTage:MAXimum?
This command is used to query the maximum voltage.
Command Syntax
PEAK:VOLTage:MAXimum?
Examples
PEAK:VOLT:MAX?
Returned Parameters
<NR2>
PEAK:VOLTage:MINimum?
This command is used to query the minimum voltage.
Command Syntax
PEAK:VOLTage:MINimum?

ITech IT8512A+ Specifications

General

Brand	ITech
Model	IT8512A+
Category	Test Equipment
Language	English