ITech IT8731 Programming Guide

SENSe subsystem
Copyright © Itech Electronic Co., Ltd. 104
Chapter12 SENSe subsystem
The Sense Subsystem is used to configure and control the measurement
functions of the electronic load. A function does not have to be selected before
you program its various configurations. A function can be selected any time
after it has been programmed. Whenever a programmed function is selected, it
assumes the programmed states.
SENSe:AVERage:COUNt
The command is used to specify the filter count. In general, the filter count is
the number of readings that are acquired and stored in the filter buffer for the
averaging calculation. The larger the filter count, the more filtering that is
performed.
Command Syntax
SENSe:AVERage:COUNt <NRf+>
Parameters
2 to 16 | MINimum | MAXimum | DEFault
Returned Parameters
14
Examples
SENS:AVER:COUN 10
Query Syntax
SENSe:AVERage:COUNt? [ MINimum | MAXimum | DEFault ]
Returned Parameters
<NR1>

ITech IT8731 Specifications

General

Brand	ITech
Model	IT8731
Category	Test Equipment
Language	English