IEEE-488 Command Reference
Copyright © Itech Electronic Co., Ltd. 25
*SAV <NRf>
*SRE <NRf>
*SRE?
*STB?
*TRG
*TST?
*WAI
Save Command
Service request enable
command
Service request enable
query
Read status byte query
Trigger Command
Self-test query
Wait to continue
command
Saves the current setup to the specified memory
location.
Programs the Service Request Enable register.
Reads the Service Request Enable Register.
Read the Status Byte Register.
Send a trigger to Load.
Performs a self-test and returns the result.
Wait until all previous commands are executed.
*CLS — Clear Status
This command clears the bits of the following registers:
_ Standard Event Register
_ Operation Event Register
_ Questionable Event Register
_ Channel Summary Event Register
_ Channel Event Register
_ Error Queue
Command Syntax
*CLS
Parameters
None
*ESE <NRf> — Event Enable
This command programs the Standard Event Status Enable register bits. The
programming determines which events of the Standard Event Status Event
register (see *ESR?) are allowed to set the ESB (Event Summary Bit) of the
Status Byte register. A "1" in the bit position enables the corresponding event.
All of the enabled events of the Standard Event Status Event Register are
logically ORed to cause the Event Summary Bit (ESB) of the Status Byte
Register to be set. See chapter “Programming the Status Registers” for
descriptions of the Standard Event Status registers.
The query reads the Standard Event Status Enable register.
To Next Page
Loading...
Need help?
General
