ITech IT8731 Programming Guide

SOURce Subsystem
Copyright © Itech Electronic Co., Ltd. 73
If the existing settings are outside the new range: The levels are set to the
maximum value of the new range.
Command Syntax
[SOURce:]CURRent:RANGe <NRf+>
Parameters
0 through MAX | MINimum | MAXimum | DEFault
Unit
A (amperes)
*RST Value
MAXimum (high range)
Examples
SOUR:CURR:RANGE MIN
Query Syntax
[SOURce:]CURRent:RANGe?
Returned Parameters
<NR3>
Related Commands
CURR CURR:SLEW
[SOURce:]CURRent:SLEW
This command sets the slew rate for all programmed changes in the input
current level of the electronic load. This command programs both positive and
negative going slew rates. MAXimum sets the slew to the fastest possible rate.
MINimum sets the slew to the slowest rate.
Command Syntax
[SOURce:]CURRent:SLEW[:BOTH] <NRf+>
Parameters
MINimum to MAXimum | MAXimum | MINimum | DEFault

ITech IT8731 Specifications

General

Brand	ITech
Model	IT8731
Category	Test Equipment
Language	English