Maintenance Guide
1-26
1-8-3. Assembling the Cable
(1) Apply the grease to portions where the 40058385, 40044517, and 40048070 cables are put
in the plastic rail, and place the cables and air tubes in the X-axis plastic rail as shown in the
figure below (figure viewed from A).
Check the connector orientation and take care so that the air tubes do not become warped.
Figure 1-8-3-1
Figure 1-8-3-2
(2) After the cables and air tubes have been run correctly, put the cover of the plastic rail.
Viewed from A
XY veyor-cable X plastic rail
Viewed from A
To Next Page
Loading...
Need help?
General
