− 56 −
7-12. Compensation of eyelet in lateral direction
7-13. Compensation of eyelet in longitudinal direction
7-14. Compensation of eyelet, left in longitudinal direction
Position on the top of eyelet can be moved to the
right- or left-hand.
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key ❼.
Setting can be performed –0.6 to 0.6 mm in the incre-
ments of 0.1 mm.
Shape on the top of eyelet can be expanded or con-
tracted in the longitudinal direction.
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key ❼.
Setting can be performed –0.2 to 0.6 mm in the incre-
ments of 0.1 mm.
Length of the left side on the top of eyelet can be
adjusted.
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key ❼.
Setting can be performed –0.2 to 0.6 mm in the incre-
ments of 0.1 mm.
–
+
❼
❻
–
+
❼
❻
–
+
❼
❻