– 11 –
① Installing the table reinforcing plate
1) Fix two table reinforcing plates ❷ on the table ❶ with eight bolts ❸ , eight plain washers ❹ , eight spring
washers ❺ and 16 nuts ❻.
The bolt ❸ is M6 carriage bolt length of which is 60 mm. The dimensions of the plain washer ❹ are
"φ12.5 xφ6.4 x t1.6". Spring washer ❺ is for M6 and nut ❻ is M6 (class 1).
Bolts ❸, plain washers ❹, spring washers ❺ and nuts ❻ are supplied with the kit for semi-sunken
type machine head (part number: 40157881).
(2) In the case of the semi-sunken type machine head
② Assembling the bottom cover stay (front)
1) Remove paper liners ❸ from two bottom rubbers
B ❶ and afx them on bottom cover stay ❷.
* Afx two right-side bottom rubbers B ❶ with shifted
to the left side (in the direction of the arrow) with
respect to slot A in bottom cover stay ❷.
Bolt rubber B ❶ is the head accessories. In addition, bottom cover stay ❷ are supplied with the kit
for semi-sunken type machine head (part number: 40157881).
1. Insert bottom rubbers B ❶ into the respective holes in bottom cover stay ❷ while holding them
so that their projecting side is faced downward.
2. Carefully check the location of mounting holes in left-side bottom rubbers B ❶.
③ Assembling the bottom cover stay (rear)
1) Remove paper liners ❸ from two bottom rubbers
B ❶ and afx them on bottom cover stay ❷.
* Afx two right-side bottom rubbers B ❶ with shifted
to the right side (in the direction of the arrow) with
respect to slot A in bottom cover stay ❷.
❷
❶
❶
⇦
❷
❶❶
⇦
A
A
❶
❸
❸
❷
❺
❹
❻
❸
❷
❶
Under-
side
Paper
liner
Under-
side
Paper
liner
To Next Page
Loading...
Need help?
General
