To Next Page

To Previous Page

1007.GB

E 20

5.4 Parameter Settings

To change the truck setting you must enter the master code.

The factory setting for the master code is 7-2-9-5.

When starting the truck for the first time, change the master code (see section 5.1).

Safety notes for trucks with indicator instrument (CANDIS (o))

– Parameter settings must be made carefully and only by special trained personnel .

If in doubt, consult the manufacturer's service department.

– Each setting must be monitored on the LC display of the display instrument

(CANDIS (o)). If in doubt, cancel the setting by pressing the o-key (26).

– Since changing any parameter will affect the truck's travel pattern, you must carry

out a test run in a specially designated work area.

To enter the master code:

– Press theo key

– Enter master code

Code Lock Parameters

Setting procedure for trucks without a display instrument (CANDIS (o)):

– Enter the three digit parameter number, confirm with the Set key (22).

– Enter the setting according to the parameter list or change and confirm with the Set

key (22).

If the entry is incorrect, the LED (23) of the o key (26) goes red. If you enter the

parameter number again the setting can be entered or changed.

To enter more parameters, repeat the procedure. To finish entering, press the o key

(26).

Display instrument

(CANDIS)

LED (21)

o key

LED (23)

Key 1

LED (24)

Key 2

LED (25)

Key 3

Service hours

are displayed

284.0

Green

Flashing

Off Off Off