JVC CA-MXG9BK User Manual

RX-MXG9BK
Features Guide
Features
A. Volume Control
CAUTION: Always set the VOLUME control to MIN before
turning on aconnected source such as a VCR or Record Player,
or starting any of the other sound sources such as the radio,
ice af tape, or CD player. If the VOLUME control is left turned up,
the sudden blast of sound energy can permanently damage
your hearing and/or ruin your speakers.
STEREO ETIQUETTE
Have consideration for others.
Set the volume toa level which will not disturb others. At night,
the CA-MXG9BK can still be enjoyed at low volume levels.
Close the window or use headphones to avoid disturbing
others.
TNonWar B. Bass Control
You can reduce or increase the amount of Bass reinforcement by adjusting the
TWIN BASS control. When set to the NORMAL position, no bass reinforcement
is applied.
C. Balance Control
If the sounds you hear from the right and left speakers are unequal, you can adjust
the speaker output balance with the BALANCE control.
D. High-fidelity Playback
When the SOURCE DIRECT button is pressed, the LED on the button comes on
and “DIRECT ON” appears on the display. By bypassing the GRAPHIC
EQUALIZER's effects, the path of the audio signal will be shortened, giving a
higher fidelity sound.
E. Special Effects Controls:
SEA Preset Pattern, Panoramic Surround mode, DSP Programs (Dolby Pro
Logic, DAP, DSEP)
Experiment with and set your special effects. If you don't want to use the effect,
just press the DSP button. “DSP OFF” appears on the display.
: SEA:
pie . When the PRESET button is pressed, the LED on the SEA button also comes
: on. Each time you press the PRESET button, the SEA pattern will change.If you
don’t want to use the effect pattern, just press the SEA button, and when the
LED goes off, so does the SEA effect.
DOLBY PRO LOGIC:
When either the PRO LOGIC or 3CH LOGIC button is pressed, the LED on
the DSP button also comes on, and “PRO LOGIC” or “3CH LOGIC” appears
PRESET on the display. To turn off the PRO LOGIC effects, just press the DSP button.
DAP: Digital Acoustic Processor
When the DAP mode buttons are pressed, the LED on the PANORAMIC
SURROUND button and the DSP button also comes on. If you don't want to
use the effect pattern, just press the DSP button.
(Cem T om [oe [= | oemn)) , DSEP: Digital Special Effects Processor
When the DSEP mode buttons are pressed, the LED on the DSP button also
comes on. If you don't want to use the effect pattern, just press the DSP button.
* Youcan'tuse the DAP effect and the DSEP effect at the same
time.
Panoramic Surround:
- When the PANORAMIC SURROUND button is pressed, the LED on the
GEscscor) button comes on. The angle of the Optional Panoramic shifting speakers will
shift in accordance with the DSP modes. To turn off a Panoramic Surround
effect, just press the PANORAMIC SURROUND button again. When the LED
goes off, so does the Panoramic Surround effect. When you want to cancel the
DSP mode, press the DSP button. The LED on the button goes off.
(No.20434) 1-11

JVC CA-MXG9BK Specifications

General

Brand	JVC
Model	CA-MXG9BK
Category	Stereo System
Language	English