JVC CA-MXG9BK User Manual

RX-MXG9BK
TUNER CD DSP
FM MODEMUTE
TUNER
ENTRY
a VOLUME
a
Set the AM Tuner Interval Spacing
Tuning in a Preset Station
The Remote is very useful for this because you can select channels by number
using the 10 keys.
1. Set the TUNER/CD/DSP selector to the TUNER position.
2. Press the 10 keys to select the channel you want.
You can also tune in the stations by using the PRESET< or> button
on the main Unit. Each time you press the PRESET < or > button, the
channel increases or decreases by one. If you hold the button down,
the tuner will cycle through the stations one after another.
Selecting the FM Tuning Mode
When an FM stereo broadcast is hard to receive or noisy:
Press the FM MODE/MUTE button on the main Unit so that reception
improves, although you lose the stereo effect. In this state, you will hear noise
while tuning into stations. MONO lights up on the display.
To restore stereo effect
Press the FM MODE/MUTE button again so that AUTO appears on the
display.
In this state, when a program is broadcast in stereo, you will hear stereo sound;
when in monaural, you will hear monaural sounds. In this state, you won't
hear noise while tuning into stations.
Using the Tuner Entry Function
When the CD or tape playback ends, the source will automatically switch to
TUNER. Your listening enjoyment will thereby not be interrupted. So with Tuner
Entry on, the Unit automatically shifts to the most recently tuned radio station
when a tape or CD comes to an end.
Press the TUNER ENTRY button.
The LED next to it lights up when Tuner Entry is on and is off when Tuner Entry
is off.
When the CD or tape playback ends, the source will switch to the most recently
tuned radio station tuned.
Note
In five situations even if Tuner Entry is on, it will not take effect, and the source will not
switch to TUNER after the CD or tape playback ends.
1) When you intentionally stop the CD or tape deck by pressing the STOP/CLEAR @ button
on the CD player or the @ button on the tape deck.
2) When any timer activated CD or tape stops playing.
3) When you set the REVERSE MODE to the c2> position.
4) When you set REPEAT or REPEAT I playing.
5) When you set AUTO POWER OFF.
Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing.
1. To select the 10 kHz interval, be sure the power is off, but the Unit is plugged into the wall socket. Hold down the PRESET > button and
press the POWER ON/STANDBY button.
Now the 10 kHz interval is selected.
2. To change back from 10 kHz to the factory setting of 9 kHz, be sure the power is off, but the Unit is plugged into the wall socket. Hold
down the PRESET < button and press the POWER ON/STANDBY button, and the CA-MXG9BK in now set for 9 kHz spacing.
1-30 (No.20434)
Page 28

JVC CA-MXG9BK Specifications

General

Brand	JVC
Model	CA-MXG9BK
Category	Stereo System
Language	English