10-16 DK55
069OA23A
(1) Oil Filter Cartridge
EVERY 200 HOURS
REPLACING ENGINE OIL FILTER
1. Remove the oil filter.
2. Put a film of clean engine oil on the
rubber seal of the new filter.
3. Tighten the filter quickly until it con-
tacts the mounting surface.
Tighten filter by hand an additional half
turn only.
4. After the new filter has been replaced,
the engine oil normally decreases a
little. Make sure that the engine oil does
not leak through the seal and be sure
to check the oil level on the dipstick.
Then, replenish the engine oil up to
the prescribed level.
CAUTION
To avoid personal injury:
Be sure to stop the engine be-
fore changing oil filter cartridge.
Allow engine to cool down
sufficiently, oil can be hot and can
burn.
IMPORTANT
To prevent serious damage to the
engine, use only a KIOTI genuine
filter.
6. Check temperature of electrolyte, if it
reaches 40°C (105°F), lower the
charging rate. When temperature is too
high, reduce charging rate and charge
for a proportionately longer period.
7. If the tractor is stored after original
charge, periodically recharge as
shown below :
A battery is fully charged when the
cells are all gassing freely and the
specific gravity ceases to rise for
three consecutive readings taken at
hour intervals. Specific gravity shall
then be adjusted to showed in Table
1.
8. Check electrolyte level two hours af-
ter chargingis finished and correct it.
< Table 3 >
about 5 hours
10
30
Period of storage
from manufacture
(months)
Fresh charging
(times)
0 ~ 6
6 ~ 12
over 12
To Next Page
Loading...
Need help?
General
