PERIODIC SERVICE 10-19
CHANGING TRANSMISSION FLUID
069OA31A
069OA30A069OA29A
(1) Tie Rod
(2) Lock Nuts
ADJUSTING TOE-IN
(A) Wheel - to - wheel distance at rear
(B) Wheel - to - wheel distance at front
1. Park tractor on a flat place.
2. Turn steering wheel so front wheels
are in the straight ahead position.
3. Lower the implement, lock the park
brake and stop the engine.
4. Measure distance between tire beads
at front of tire, hub height.
5. Measure distance between tire beads
at rear of tire, hub height.
6. Front distance should be 2 to 8 mm
less than rear distance. If not, adjust
tie rod length.
ADJUSTING PROCEDURE
1. Loosen the lock nut and turn the turn-
buckle to adjust the rod length until the
proper toe-in measurement is obtained.
2. Retighten the lock nut.
EVERY 300 HOURS
(1) Oil Filter Cartidge (2) Rear Axle Shaft
(1) Drain Plug
To Next Page
Loading...
Need help?
General
