10-8 DK55
069OA13A
069OA11A 069OA12A
(1) 137 N·m (14 kgf·m, 100 ft·lbs)
(2) 215 N·m (22 kgf·m, 160 ft·lbs)
Check wheel bolts and nuts regularly
especially when new. If they are loose,
tighten them as above.
CHECKING WHEEL BOLT TORQUE
CAUTION
To avoid personal injury:
Never operate tractor with a
loose rim, wheel, or axle.
Any time bolts and nuts are
loosened, retighten to specified
torque.
Check all bolts and nuts fre-
quently and keep them tight.
EVERY 100 HOURS
CHANGING ENGINE OIL
1. To drain the used oil, remove the drain
plug at the bottom of the engine and
drain the oil completely into the oil pan.
All the used oil can be drained out
easily when the engine is still warm.
2. After draining reinstall the drain plug.
3. Fill with the new oil up to the upper
notch on the dipstick.
Oil
capacity
with filter
DK55
(1) Oil Inlet
(2) Dipstick
(A) Oil level is acceptable within this range
(1) Drain Plug
CAUTION
To avoid personal injury:
Be sure to stop the engine be-
fore changing the oil.
Allow engine to cool down suffici-
ently, oil can be hot and can burn.
8.5 (2.2 U.S.gal.)
To Next Page
Need help?
General
