PERIODIC SERVICE 10-3
069OA03A
1. Turn the key switch to “ON”, check
the amount of fuel by fuel gauge.
2. Fill fuel tank when fuel gauge shows
1/4 or less fuel in tank.
3. Use grade No.2-Diesel fuel at tem-
peratures above -10°C (14°F).
IMPORTANT
Do not permit dirt or trash to get
into the fuel system.
Be careful not to let the fuel tank
become empty, otherwise air will
enter the fuel system, necessi-
tating bleeding before next en-
gine start.
Be careful not to spill during
refueling. If should spill, wipe it
off at once, or it may cause a fire.
To prevent condensation (water)
accumulation in the fuel tank, fill
the tank before parking overnight.
NOTE
No.2-D is a distillate fuel of lower vola-
tility for engines in industrial and heavy
mobile service. (SAE J313 JUN87)
Grade of Diesel Fuel Oil According to
ASTM D975
Distillation
Temperatures,
°C(°F) 90%
Point
Min
282
(540)
Max
338
(640)
Viscosity
Kinematic
cSt or mm
2
/s
at 40°C
Min
1.9
Max
4.1
Viscosity
Saybolt,
SUS at
100°F
Min
32.6
Max
40.1
sulfur,
weight
%
Max
0.50
Cop-
per
Strip
Cor-
rosion
Max
No.3
Cet-
ane
Num-
ber
Min
40
Flash
Point,
°C (°F)
Water and
Sediment,
volume %
Carbon
Residue on,
10 percent
Residuum,
%
Ash,
weight %
Min
52 (125)
Max
0.05
Max
0.35
Max
0.01
CHECKING ENGINE OIL LEVEL
(1) Oil Inlet (2) Dipstick
(A) Oil Level Is Acceptable Within Range
IMPORTANT
When using an oil of different
maker or viscosity from the pre-
vious one, remove all of the old
oil. Never mix two different types
of oil.
If oil level is low, do not run engine.
To Next Page
Loading...
Need help?
General
