Table of Contents
TP-6881 7/15 Table of Contents
Safety Precautions and Instructions 5.........................................................
Introduction 9...............................................................................
List of Related Materials 9......................................................
Service Assistance 10.........................................................................
Section 1 Specifications 11...................................................................
1.1 Introduction 11...........................................................
1.2 Controller Specifications 11................................................
1.3 Engine Service 11........................................................
1.4 Engine Specifications 11..................................................
1.5 Alternator Specifications 12................................................
1.6 Torque Specifications 12..................................................
1.7 Service View 13..........................................................
Section 2 Scheduled Maintenance 15..........................................................
2.1 Service Schedule 16......................................................
2.1.1 Service Schedule 17..............................................
2.2 Lubrication System 18....................................................
2.2.1 Low Oil Pressure Shutdown 18.....................................
2.2.2 Oil Check 18.....................................................
2.2.3 Engine Oil Recommendation 18....................................
2.2.4 Oil Change Procedure 18..........................................
2.2.5 Resetting the Maintenance Timer 20................................
2.3 Spark Plugs 20...........................................................
2.4 Air Cleaner Service 21....................................................
2.4.1 Air Cleaner, 8RESV/RESVL Models 21..............................
2.4.2 Air Cleaner, 10/12RESV/RESVL Models 22..........................
2.5 Cooling System 23.......................................................
2.6 Exhaust System 23.......................................................
2.7 Stepper Motor Coupling 24................................................
2.8 Fuel System Maintenance 24..............................................
2.9 Battery 25...............................................................
2.9.1 Checking Electrolyte Level 26......................................
2.9.2 Checking Specific Gravity 26.......................................
2.10 Storage Procedure 27.....................................................
2.10.1 Lubricating System 27............................................
2.10.2 Fuel System 27..................................................
2.10.3 Cylinder Lubrication 27............................................
2.10.4 Exterior Preparation 27............................................
2.10.5 Battery 27.......................................................
Section 3 Controller 29.......................................................................
3.1 Introduction 29...........................................................
3.2 SiteTech and OnCue Plus Software 29......................................
3.3 Controller Parameters 30..................................................
3.3.1 Controller Parameters Table 30.....................................
3.3.2 Notes on Selected Parameters 30..................................
3.4 Controller Firmware 44....................................................
3.5 Controller Replacement 45................................................
3.5.1 Controller Replacement Procedure 45...............................
3.6 Controller Setup 47.......................................................
3.7 Voltage Calibration 50.....................................................
3.7.1 Calibration using the RDC2 Controller Keypad and Menus 50..........
3.7.2 Calibration Using SiteTech 52......................................
3.8 Setting the OnCue Plus Password 53.......................................
3.8.1 RDC2 Controller 53...............................................
3.8.2 DC2 Controller 53................................................
Section 4 Troubleshooting 55.................................................................
4.1 Introduction 55...........................................................
4.2 Theory of Operation, Electronic Start Sequence 55...........................