2-71
12. OPERATION
12.16 CHECK AFTER STOPPING ENGINE
1. Walk around the machine and check the work equipment, body
work, and undercarriage, and check also for leakage of oil and
water. If any leakage or abnormality is found, carry out repairs.
2. Fill the fuel tank.
3. Remove any waste paper or dead leaves from inside the engine
room. These may cause a fire.
4. Remove any mud stuck to the undercarriage.
12.17 LOCKING
Always lock the following places.
1 Engine side panel (left, right)
2 Cab door (left, right)
3 Engine hood at rear of cab (2 points)
4 Fuel tank filler cap
5 Hydraulic tank filler cap
REMARK
The starting switch key is used also for locks 1, 2, 3, 4 and
5.
To Next Page
Loading...
Need help?
General
