3-67
24. SERVICE PROCEDURE
24.8 EVERY 1000 HOURS SERVICE
WARNING
Be sure to put a warning tag on work equipment control levers
1.
Maintenance for every 50, 100, 250 and 500 hours should be
carried out at the same time.
24.8.1 CHANGE OIL IN TRANSMISSION CASE, CLEAN
STRAINER
WARNING
‡ Apply the parking brake, and lock the front and rear frames
with the safety bar and pin.
‡ Set the work equipment in a stable condition, then stop the
engine and apply the locks securely to the work equipment
control levers.
‡ The oil is at high temperature immediately after the machine
has been operated. Wait for the oil to cool down before
carrying out maintenance.
‡ Container to catch drained oil: Min. 140 ¬ capacity
‡ Refill capacity: 140 ¬ (37.0 US gal)
1. Set a container to catch the oil under drain plugs 1 and 2, then
remove drain plug 1 and loosen plug 2 to drain the oil.
To prevent the oil from pouring out suddenly, loosen drain plug
2 and remove it gradually.
2. After draining the oil, install drain plugs 1 and 2.
3. Set a container to catch the oil under the transmission filter.
4. Remove transmission filter drain plugs 3 (6 pieces), drain the
oil, then tighten the plug again.
To Next Page
Loading...
Need help?
General
