3-68
24. SERVICE PROCEDURE
5. Remove bolt 4, then remove cover 5 and take out strainer 7
together with spring 6.
6. Remove any dirt stuck to strainer 7, then wash it in clean diesel
oil or flushing oil. If strainer 7 is damaged, replace it with a new
part.
8. Pour in the specified amount of engine oil from oil filler F.
For details of the oil to use, see “20. USE OF FUEL, COOLANT
AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”.
9. After filling with oil, check that the oil is at the specified level. For
details, see “24.2 WHEN REQUIRED”.
10. Check for oil leakage from the transmission case and filter.
Make an oil level check before starting engine or 60 minutes or
more after the engine is stopped.
If oil remains at various portions, the correct oil level cannot be
measured.
24.8.2 CLEAN TRANSMISSION CASE BREATHER
Remove all mud and dirt from around the breather, then remove
the breather. Put in cleaning fluid and clean the breather.
Take care not to allow dust and dirt to enter the transmission
case through the port while the breather is removed.
7. Install spring 6 and strainer 7 to cover 5.
Replace the O-ring on the cover with a new part, then install the
cover.
To Next Page
Loading...
Need help?
General
