3-72
24. SERVICE PROCEDURE
24.8.7 REPLACE CORROSION RESISTOR CARTRIDGE
1. Open the engine side cover located on the right of the engine
hood.
2. Screw in valve 1 at the side of the corrosion resistor.
3. Using the filter wrench provided, remove cartridge 2 by turning
it counterclockwise.
4. Coat the seal surface of the new cartridge with engine oil, and
install it to the filter holder.
5. When installing, bring the gasket into contact with the seal
surface of the filter holder, then tighten approx. 2/3 turns.
6. After replacement, open valves 1.
After replacing the cartridge, start the engine and check that
there is no leakage of water from the filter seal surface.
To Next Page
Loading...
Need help?
General
