.
OPERATION
OPERATION
OPERATION
OPERATION
3. When in the operator's compartment, pull retarder control lever
(5) fully to apply the retarder.
NOTICE
The retarder must not be used as a parking brake.
Do not use the retarder for long-term parking, regardless of the engine
speed.
CHECKS AFTER COMPLETION OF WORK
Use the machine monitor to check the engine water temperature, engine oil pressure, and fuel level. If the engine
has overheated, do not stop the engine suddenly. Run it at a mid-range speed to cool it gradually before stopping.
DRAIN WATER FROM AIR TANK
1.
After starting the engine, pull ring (1) of the tank drain valve to
drain the water from the tank.
2.
Carry out the same operation after completing work.
NOTICE
In cold areas, there is danger of the water freezing, so drain the water from
the air tank after operations when it is still warm.
LOCKING
Always lock the following places.
(1) Fuel filler cap of fuel tank
(2) Cab door (left)
Lock the right side door manually from the inside (operator's
seat).
REMARK
The starting switch key is used for locking places (1) and (2).
3 - 101
To Next Page
Loading...
Need help?
General
