.
SAFETY
PRECAUTIONS FOR MAINTENANCE
PRECAUTIONS FOR HIGH VOLTAGE
When the engine is running or immediately after it has stopped,
high voltage is generated at the injector terminal and inside the
engine controller, so there is danger of electrocution. Never touch
the injector terminal or the inside of the engine controller.
If it is necessary to touch the injector terminal or the inside of the
engine controller, please contact your Komatsu distributor.
WASTE MATERIALS
To prevent pollution, pay careful attention to the method of disposing of waste materials.
Always put oil drained from your machine in containers. Never
drain oil directly onto the ground or dump into the sewage
system, rivers, the sea, or lakes.
Obey appropriate laws and regulations when disposing of
harmful objects such as oil, fuel, coolant, solvent, filters, and
batteries.
MAINTENANCE OF AIR CONDITIONER
If air conditioner refrigerant gets into your eyes, it may cause blindness; if it touches your skin, it may cause frostbite.
Never touch refrigerant.
COMPRESSED AIR
When carrying out cleaning with compressed air, there is a hazard of serious injury caused by flying particles.
When using compressed air to clean elements or the radiator, always wear safety glasses, dust mask, gloves,
and other protective equipment.
PERIODIC REPLACEMENT OF SAFETY-CRITICAL PARTS
In order for the machine to be operated safely for a long time, it is necessary to add oil and to carry out service
and maintenance at periodic intervals. In order to further increase safety, components with a strong relationship
to safety, such as hoses and seat belts, must be replaced at periodic intervals.
Replacement of safety-critical parts: See "PERIODIC REPLACEMENT OF SAFETY CRITICAL PARTS (PAGE
4-17)".
The material of these components naturally changes over time, and repeated use causes deterioration, wear, and
fatigue. As a result, there is a hazard that these components may fail and cause serious injury or death. It is
difficult to judge the remaining life of these components from external inspection or the feeling when operating,
so always replace them at the specified interval.
Replace or repair safety-critical parts if any defect is found, even when they have not reached the specified
replacement time.
2 - 32
To Next Page
Loading...
Need help?
General
