.
ATTACHMENTS, OPTIONS
ASR-II (AUTOMATIC SPIN REGULATOR II)
RETARDER CONTROL LEVER
When ASR is operated, if the retarder gets started with this lever (5), ASR system stopps its operation.
ACCELERATOR PEDAL
ASR system operates only when the pedal (6) is depressed with the travel speed range of 0 to 30km/h (0 to 18.6
MPH). If stopps depressing the pedal, ASR system stopps its operaton.
BRAKE PEDAL
When ASR is operated, if this pedal (7) is depressed, ASR system stopps its operation.
ACTUATION OF ASR-II SYSTEM
ASR system can function under the condition that the system switch is turned on. ASR operation lamp lights up
when the system detects slippage of the rear wheels and the ASR starts functioning.
PRECAUTIONS WHEN USING
WARNING
ASR system operates when the system switch is turned on.
If abnormality occurs in the system and the travel cannot be controlled securely, the system is turned off with the warning
buzzer sound and the operation of the system stops. Stop the machine in a safe place immediately to turn off the system
switch.
Even with the ASR system installed, there may be instances where the machine can not travel safely such as on a road having
an extremely low coefficient of friction (a frozen road, etc.) or on a steep slope.
On a slippery road, more air is consumed by the operation of ASR. If the air pressure drops and the warning buzzer sounds,
stop the machine in a safe place. Wait until the air pressure is restored sufficiently, then start again.
The machine can be driven normally even if the ASR system switch is turned off. In this case, however, watch
out for lateral skidding of the machine on slippery roads.
If both rear wheels slip at the same speed, the ASR will not function. In this case, adjust the engine output with
the accelerator pedal.
6 - 46
To Next Page
Loading...
Need help?
General
