.
ATTACHMENTS, OPTIONS
HANDLING AUTO-GREASING SYSTEM
HANDLING AUTO-GREASING SYSTEM
With this system, the grease is automatically supplied through the computer controls.
METHOD OF OPERATING AUTO-GREASING SYSTEM
1.
Turn the starting switch ON.
REMARK
Immediately after the power is turned on, all display lamps on the lubrication controller inside the console box will
light up for several seconds. This is a self-check for the lamps, and does not indicate any abnormality.
The display portion for starting the calculation of the greasing interval will flash, but all other displays will go out after
a few seconds.
However, even if the greasing interval has not been reached, if the switch is turned ON/OFF repeatedly, greasing
will automatically start due to the function of the supplemental circuit, immediately after the starting switch is turned
ON. After display of the 7-segment LED and greasing-in-progress LED, as shown in the "LUBRICATION
CONTROLLER DISPLAY TABLE", the above condition will be returned.
2. Centralized greasing is carried out in accordance with the set time and frequency limit for greasing.
LUBRICATION CONTROLLER DISPLAY TABLE
(1)
(2)
(3)
(4)
(5)
7-segment LED
Cancel key
Level selector key
Blade-type fuse
Power source LED
(6)
(7)
(8)
(9)
(10)
Greasing LED
Warning LED
Setting LED
Starting key
Item selector key
Remaining number of times of greasing
If the remaining number of times of greasing is less than 10,
remaining number is displayed and it flashes. If the remaining
number of times is 10 or more, only the flashing is shown without
displaying the number.
6 - 31
To Next Page
Loading...
Need help?
General
