.
OPERATION
MACHINE OPERATIONS AND CONTROLS
OPERATION
MACHINE OPERATIONS AND CONTROLS
4. Set lock lever (3) in the LOCK position (L).
MACHINE INSPECTION AFTER DAILY WORK
Before Stop Engine
Check the engine coolant temperature, engine oil pressure, and
fuel level on the machine monitor.
REMARK
After stopping the engine, if the starting switch is turned within
approx. 10 seconds to the ON or START position to start the
engine again, the monitor display is not reset, and the screen
before the starting switch was turned OFF is displayed.
After Stop Engine
1.
Walk around the machine and check the work equipment, machine exterior, and undercarriage, also check for
any leakage of oil or coolant. If any problems are found, repair them.
2.
Fill the fuel tank.
3.
Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
4. Remove any mud affixed to the undercarriage.
3 - 126
To Next Page
Loading...
Need help?
General
