.
SAFETY
PRECAUTIONS FOR OPERATION
PRECAUTIONS WHEN TRAVELING IN FORWARD OR REVERSE AND SWINGING
When traveling, drive with sprocket (1) at the rear of the
machine. If sprocket (1) is at the front, the operation of the travel
levers will be the opposite of the actual direction of travel, so
there is a hazard that the machine may travel in an unexpected
direction, leading to serious injury or death.
Always lock all the door and windows of the operator's
compartment in position (open or closed).
On jobsites where there is a hazard of flying objects or of objects
entering the operator's compartment, check that all the door and
windows are securely closed.
Do not allow anyone apart from the operator to ride on the
machine.
If there are any persons in the area around the machine, there
is danger that they may be hit or caught by the machine, and this
may lead to serious personal injury or death. Always observe
the following before traveling.
Always operate the machine only when seated.
Before moving off, check it again that there is no person or
obstacle in the surrounding area.
Before starting to move, sound the horn to warn people in the
surrounding area.
Check that the travel alarm and other alarms work properly.
If there is an area to the rear of the machine that cannot be
seen, position a signalman. Swing slowly and be extremely
careful not to hit any person or object.
Always be sure to carry out the above precautions even when the
machine is equipped with mirrors.
2 - 25
To Next Page
Loading...
Need help?
General
