OPERATION OPERATION
3-97
3. Pull parking brake lever (4) and set it to the LOCK position.
4. Operate lift arm control lever (5) to lower the bucket to the
ground.
5. Check that the work equipment control lever is at the
HOLD position, then set safety lock lever (6) to the LOCK
position.
CHECK AFTER STOPPING ENGINE 3
Check the engine water temperature, engine oil pressure, HST oil temperature, and fuel level with the meters and
lamps.
If the engine has overheated, do not stop it suddenly. Run the engine at a midrange speed to allow the engine to
cool down before stopping it.
CHECKS AFTER COMPLETION OF OPERATION 3
1. Walk around the machine and check the work equipment, body work, and undercarriage, and check also for
oil and water leakage.
2. Fill the fuel tank.
3. Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
4. Remove any mud affixed to the undercarriage.
To Next Page
Loading...
Need help?
General
