.
OPERATION
OPERATION
CHECKS AFTER COMPLETION OF OPERATION
BEFORE STOPPING ENGINE
Check the engine water temperature, engine oil pressure, torque converter oil temperature, and fuel level with the
machine monitor.
If the engine has overheated, do not stop it suddenly. Run the engine at a midrange speed to allow the engine to
cool down before stopping it.
AFTER STOPPING ENGINE
1. Walk around the machine and check the work equipment, bodywork, and undercarriage, and check also for oil
and water leakage.
2.
Fill the fuel tank.
3. Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
4.
Remove any mud affixed to the undercarriage.
LOCKING
Always lock the following parts.
(1) Fuel tank filler cap
(2) Engine side panel (2 points)
(3) Cab door (2 points)
REMARK
The starting switch key is used also for locks (1), (2), and (3).
3 - 139
To Next Page
Loading...
Need help?
General
