.
MAINTENANCE
SERVICE PROCEDURE
EVERY 4000 HOURS SERVICE
Maintenance for every 50, 100, 250, 500, 1000 and 2000 hours service should be carried out at the same time.
LUBRICATING
Carry out the greasing once every two years, regardless of whether the 4000 hour interval has passed.
1.
Set the grease fitting marked by arrows on the front drive shaft facing down.
2. Using a grease pump, pump in grease through the grease fittings marked by the arrows.
3.
After greasing, wipe off any old grease that was pushed out.
(1) Center drive shaft spline (1 place)
(2) Front drive shaft (2 places)
(3) Rear drive shaft (2 places)
(4) Center drive shaft (2 places)
4 - 64
To Next Page
Loading...
Need help?
General
