3.3 Operation Operation
3-136 WA470-6H – VEAM946100
V-shape loading
Position the dump truck so that the direction of approach of the
wheel loader is approx. 60 degrees from the direction of
approach to the stockpile. After loading the bucket, drive the
wheel loader in reverse, then turn it to face the dump truck and
travel forward to load the dump truck.
The smaller the turning angle of the wheel loader is, the more
efficient the operation becomes.
When loading a full bucket and raising it to the maximum height,
first shake the bucket to stabilize the load before raising the
bucket. This will prevent the load from spilling to the rear.
Precautions when piling up loads
When forming products into a pile, be careful not to let the rear
counterweight come into contact with the ground.
Do not set the bucket to the DUMP position when piling-up
loads.
REMARK
When carrying out scooping-up work, avoid using the transmis-
sion cut-off function as far as possible. It will prevent the
machine from moving back.
When using the transmission cut-off function, lower the cut-off
position so that cut-off function is actuated, when the brake
pedal is deeply depressed, while ensuring ample braking force.
GK032213
GK032214
To Next Page
Loading...
Need help?
General
