3.3 Operation Operation
3-114 WA470-6H – VEAM946100
3.3.6 Moving the machine (directional, speed), stopping the machine
WARNING
! Always remove the frame lock bar for travel operations. If it
is not removed, the steering wheel cannot be used for steer-
ing, and this may lead to serious damage or injury.
! When moving the machine, check that the area around the
machine is safe, then sound the horn before starting.
! Do not allow people to get near the machine.
! Clear the machine's travel path of any obstacle.
! Pay particular attention to the blind spot at the rear of the
machine when traveling in reverse.
! When starting the machine off up a slope, set the transmis-
sion cut-off switch to the OFF position, depress the left brake
pedal. Then depress the accelerator pedal and gradually
release the brake pedal to start the machine off. This makes
it possible to prevent the machine from rolling back.
Preparations for moving the machine
1. Check that warning pilot lamp (1) is not lighted up.
GK038005
1
GK038083
5
2 368
794
To Next Page
Loading...
Need help?
General
