1.2 Safety information Foreword
1-6 WA470-6H – VEAM946100
1.2.2 Safety labels
Safety labels are affixed to the machine to inform the operator or
maintenance worker on the spot when carrying out operation or
maintenance of the machine that may involve hazard.
For details of safety labels, see "Safety labels (2-2)".
Safety labels using pictogram
Safety pictograms use a picture to express a level of hazardous
condition equivalent to the signal word. These safety pictograms
use pictures in order to let the operator or maintenance worker
understand the level and type of hazardous condition at all
times. Safety pictograms show the type of hazardous condition
at the top or left side, and the method of avoiding the hazardous
condition at the bottom or right side. In addition, the type of haz-
ardous condition is displayed inside a triangle and the method of
avoiding the hazardous condition is shown inside a circle.
KOMATSU cannot predict every circumstance that might involve
a potential hazard in operation and maintenance. Therefore, the
safety messages in this manual and on the machine may not
include all possible safety precautions.
If any procedures or actions not specifically recommended or
allowed in this manual are used, it is your responsibility to take
the necessary steps to ensure safety.
In no event should you engage in prohibited uses or actions
described in this manual.
The explanations, values, and illustrations in this manual were
prepared based on the latest information available at that time.
Continuing improvements in the design of this machine can lead
to changes in detail which may not be reflected in this manual.
Consult KOMATSU or your KOMATSU distributor for the latest
available information of your machine or for questions regarding
information in this manual.
GK032002
Part No
To Next Page
Loading...
Need help?
General
