4.9 Service procedure
When required Maintenance
4-40 WA470-6H – VEAM946100
Check axle oil level, add oil
WARNING
! When checking the oil level, apply the parking brake and
secure the front and rear frames with the safety bar.
! After stopping the engine, the parts and oil are at a high tem-
perature. Wait for the temperature to go down before starting
the operation.
Carry out this procedure if there is any sign of oil on the axle
case.
Carry out the inspection with the machine on a horizontal road
surface.
(If the road surface is at an angle, the oil level cannot be
checked correctly.)
! A: Front
! B: Rear
1. Stop the engine and remove oil level plug (1).
REMARK
Remove the mud and dirt from around plug (1), then remove the
plug.
2. Wipe off any oil adhering to the oil level gauge attached to
plug (1) with cloth.
3. Set the oil level gauge (G) as shown in the right diagram.
4. The oil level is correct when it is between the two lines pro-
vided on the oil level gauge.
If the oil level does not reach the lower line, add axle oil
through filler port (F).
REMARK
For axles with ASD (Limited-Slip Differential), the brand of lubri-
cating oil is different. Use the specified lubricating oil.
5. If the oil level is above the upper line, drain off the excess oil
through drain plug (P) and check the oil level again.
6. If the oil level is correct, install plug (1).
Tightening torque: 127 to 177 Nm
GK043061
A
1
P
GK043062
B
1
P
GK032253
Oil level range
Axle
assembly
(spot facing face)
measuring location
Oil level
1
F
G
To Next Page
Loading...
Need help?
General
