Foreword 1.7 CE-Conforming equipment
WA470-6H – VEAM946100 1-23
1.7.2 Manufacturer-supplied CE-Conforming equipment, according to
document 419-93-H1250
The responsibility for observing valid regulations in the case of
wheel loaders with "interchangeable equipment" (e.g. bucket or
fork-lift) which was not supplied from works lies with the cus-
tomer which was subsequently fitted to the machine.
The directives for CE conformity and road-traffic registration are
deemed to have been fulfilled when the manufacturer of the
equipment confirms fulfilment of the form 419-93-H1250 along-
side.
The certification must be sent to the customer and the wheel
loader manufacturer. The CE conformity declaration for a spe-
cific wheel loader is only legally valid once this has taken place.
The dimensions X1, X2, Y1 and Y2 must be provided by the cus-
tomer for approval for use on public roads. (valid in Germany)
The dimension Sh (smallest tyre radius) must be added to the
dimension D2.
The figure G (in kg) represents the maximum load (equipment
and operating load) which may act upon this point.
GK032013
D2
Sh
X1
Y1
Y2
X2
Sh
A2
A1
G
To Next Page
Loading...
Need help?
General
