4.9 Service procedure
When required Maintenance
4-48 WA470-6H – VEAM946100
Replace bucket teeth
Bucket with tip tooth
(Option)
CAUTION
! If the pin is hit out with strong force, there is danger that the
pin may fly out. Check that there is no one in the surrounding
area.
! There is danger of pieces flying during the replacement
operation, so always wear protective clothing, such as safety
glasses and gloves.
Replace the teeth before they wear down as far as the adapter.
1. Raise the bucket to a suitable height, then put blocks under
the bucket to prevent the bucket from coming down.
Raise the bucket so that the bottom surface of the bucket is
horizontal.
2.
Remove pin (2) installed to the bucket, then remove tooth (1).
Put a rod (slightly narrower than the pin) in contact with the
hatched portion (either left or right) and tap pin (2) out to the
opposite side.
3. Fit new tooth (1) in adapter (3), push in pin (2) partially by
hand, then knock it in with a hammer.
4. After operating the machine for a few hours, check that the
pin does not come out.
GK032259
1
2
GK032260
1
2
3
To Next Page
Loading...
Need help?
General
