4.9 Service procedure
Maintenance Every 2000 hours service
WA470-6H – VEAM946100 4-83
If the disc is near the wear limit, carry out inspection at
shorter intervals, regardless of the specified inspection inter-
val.
4. Install cap nut (1).
Tightening torque: 29.4 to 39.2 Nm
REMARK
On new machines, the position of the guide is adjusted so that
the end face of rod (2) comes to the end face of guide (3). For
this reason, do not loosen locknut (4) except when replacing the
disc.
Carry out the operation with two workers: one worker depresses
the brake pedal and the other worker pushes in rod (2).
To Next Page
Loading...
Need help?
General
