Safety 2.4 Precautions for maintenance
WA470-6H – VEAM946100 2-35
Maintenance with engine running
! Stop the machine on firm, level ground.
! Select a place where there is no hazard of falling rocks or
landslides, or of flooding if the land is low.
! Lower the work equipment completely to the ground and
stop the engine.
! After stopping the engine, turn the starting switch to the ON
position, operate work equipment control lever (1) fully in the
RAISE and LOWER directions 2 - 3 times to release the
remaining pressure in the hydraulic circuit, then set work
equipment lock lever (2) to the LOCK position.
After releasing the remaining pressure in the hydraulic cir-
cuit, turn the starting switch to the OFF position.
Check that the battery relay is off and main power is not con-
ducted. Wait for approx. one minute after turning off the
engine starting switch key and press the horn switch. If the
horn does not sound, it is not activated.
! Set parking brake switch (3) to the ON position, then put
blocks under the front and the rear of the tires.
GK032073
GK038014
1
GK038007
2
Free
Lock
GK038008
3
ONOFF
GK050018
To Next Page
Loading...
Need help?
General
