OPERATING THE MACHINE
5-38
PRECAUTIONS FOR SPECIAL OPERATIONS
WORKING IN WATER
While operating in water or on swampy ground, the water must
not reach the underside of the axle housing. Wash the machine
after the work has been finished and check the lubricating
points.
WORKING ON SNOW
Adhere to the instructions in the chapter "Safety", "Working on
snow".
DUMPING ON STEEP SLOPES
Adhere to the instructions indicated in the chapter "Safety",
"Loading".
WORKING IN THE VICINITY OF ELECTRICAL
OVERHEAD LINES
Adhere to the instructions indicated in the chapter "Safety",
"Working Close to Overhead Power Transmission Lines".
OPERATIONONSLOPES
Adhere to the instructions indicated in the chapter "Safety",
"Driving On Slopes".
WORKING ON LOOSE SOIL
Adhere to the instructions indicated in the chapter "Safety",
"Working on loose soil".
AFTER THE WORK IS FINISHED
1. Walk around the machine and visually inspect the work unit,
the car body and the chassis. In addition, pay attention to
emerging oil and water. Eliminate immediately any fault or
defect.
2. Fill up the fuel tank.
3. Remove highly flammable material from the engine room
since it represents a fire risk.
4. Clean roughly the chassis landing gear.
To Next Page
Loading...
Need help?
General
