SAFETY MEASURES DURING OPERATION
3-19
PARKING THE MACHINE
• If possible, park the machine on an even surface. If you have
to park the machine on a slope, you must park the machine
with the work unit pointing down the slope. Lower the work
unit (1) until it firmly touches the ground, or let the cutting
edge of the bucket sink deeply into the soil. Block the wheels
with wheel chocks (2) to ensure that the machine cannot roll
away.
• When parking the machine on public roads, ensure that it
does not obstruct traffic. Put up signal lamps and required
warning signs to ensure that passing traffic can clearly see
the machine.
• Adhere to all regulations on parking vehicles and securing
building sites.
• Before you leave the machine, completely lower the work
unit onto the ground. Secure the control lever of the work hy-
draulic system against accidental operation. Switch off the
motor. Lock all points that can be locked and store the key in
asafeplace.
To Next Page
Loading...
Need help?
General
