Konica Minolta Di2010 User Manual

6.7 Configuring Functions (Soft Switches)
6
Di2010/Di2510/Di3010/Di3510 6-23
Administrator Management Operations Chapter 6
6.7 Configuring Functions (Soft Switches)
Soft switches for functions can be set according to your use.
✎
Note
Do not alter any modes or bits not mentioned in this manual.
Reference: The table below gives some sample bit (binary) and hexadecimal (16-
base) equivalents
Soft Switching Settings
Mode specification Specifies the soft switch setting item with 3 digits.
Bit specification An 8-digit number comprising the mode. Each bit from 0 to 7 is specified with
a binary number (0 or 1) to configure functions.
HEX specification Allows the functions to be set using hexadecimal numbers (a combination
of 0 to 9 and A to F).
For example, the bit specification of “0011 0000” would be “30” in
hexadecimal.
Decimal Bit specification (binary) HEX specification (hexadecimal)
0 0000 0000 00
1 0000 0001 01
2 0000 0010 02
3 0000 0011 03
4 0000 0100 04
5 0000 0101 05
6 0000 0110 06
7 0000 0111 07
8 0000 1000 08
9 0000 1001 09
10 0000 1010 0A
11 0000 1011 0B
12 0000 1100 0C
13 0000 1101 0D
14 0000 1110 0E
15 0000 1111 0F
16 0001 0000 10
:: :
255 1111 1111 FF

Konica Minolta Di2010 Specifications

General

Brand	Konica Minolta
Model	Di2010
Category	Copier
Language	English