2.5 Laser Safety
2
Di2010/Di2510/Di3010/Di3510 2-7
Safety Information Chapter 2
Therefore, the print head unit should not be opened under any
circumstances.
CDRH Regulation
This machine is certified as a Class 1 Laser product under Radiation Performance
Standard according to the Food, Drug and Cosmetic Act of 1990. Compliance is
mandatory for Laser products marketed in the United States and is reported to the
Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug
Administration of the U.S. Department of Health and Human Services (DHHS). This
means that the device does not produce hazardous laser radiation.
The label shown on page 2-9 indicates compliance with the CDRH regulations and
must be attached to laser products marketed in the United States.
This is a semiconductor laser. The maximum power of the laser diode is 5 mW and
the wavelength is 770-795 nm.
For European Users
This is a semiconductor laser. The maximum power of the laser diode is 5mW and
the wavelength is 770-795 nm.
CAUTION
Use of controls, adjustments or performance of procedures other than those
specified in this manual may result in hazardous radiation exposure.
CAUTION
Use of controls, adjustments or performance of procedures other than those
specified in this manual may result in hazardous radiation exposure.
Print Head
Laser Aperture of the
Print Head Unit
There is a laser aperture at the location
shown above, which must, however,
NEVER be viewed directly by the user.
To Next Page
Loading...
Need help?
General
