Konica Minolta Di2010 User Manual

3
3.1 Installation Precautions
3-2 Di2010/Di2510/Di3010/Di3510
Precautions Chapter 3
3.1 Installation Precautions
Installation Site
To ensure utmost safety and prevent possible malfunctions, install the copier in a
location that meets the following requirements.
- A location away from curtains, etc. that may catch fire and burn easily
- A location that is not exposed to water or other liquids
- A location free from direct sunlight
- A location out of the direct airflow of an air conditioner or heater, and not
exposed to extremely high or low temperatures
- A well-ventilated location
- A location that is not exposed to high humidity
- A location that is not extremely dusty
- A location not subjected to undue vibrations
- A stable and level location
- A location where ammonia or other organic gases are not generated
- A location that does not put the operator in the direct airflow of exhaust from the
copier
- A location that is not near any kind of heating devices
Power Source
The power source requirements are as follows.
G Voltage fluctuation: Maximum ±10% (127 V: +6%, –10% )
G Frequency fluctuation: Maximum ±0.3 Hz
❍ Use a power source with as little voltage or frequency fluctuations as possible.

Konica Minolta Di2010 Specifications

General

Brand	Konica Minolta
Model	Di2010
Category	Copier
Language	English