3.3 Charging of DR Detector
78
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• Handle the DR Detector with extreme care when in-
serting it into the AeroDR Battery Charger.
• The LED of the DR Detector is not visible when the
DR Detector is inserted into the AeroDR Battery Char-
ger.
• The wired connection connector of the DR Detector
may become warm right after charging on the AeroDR
Battery Charger. This often occurs during charging
and is not a malfunction.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT
•••••••••••••••••••••••••••••••••••••
• If there is any problem during charging, the LED (or-
ange) on the AeroDR Battery Charger will light. Also,
charging will stop when an error occurs.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
5
Remove the DR Detector from the AeroDR
Battery Charger.
• Pull the DR Detector to remove it.
3.3.2 Charging with AeroDR
Battery Charger2
Inserting the DR Detector into the AeroDR Battery
Charger2 performs charging of the DR Detector.
1
Conrm that the LED (green) of the AeroDR
Battery Charger2 is slowly ashing.
2
Slowly insert the DR Detector with its ex-
posure side pointed toward the operator
until the buzzer sounds. When inserted,
charging of the DR Detector begins.
Exposure
side
Load slowly
Exposure
side
Inserted
To Next Page
Loading...
Need help?
General
